Dodge 2006 LX Charger Installationsanleitung PDF herunterladen (Seite 36)

Dodge Charger 2006-2008 System Installation Guide

Fuel System

Fuel Injectors

Reconnect the battery.

Remove relay 46 from the panel in the

trunk.

Crank the engine for 15 seconds.

Disconnect the battery.

Unclip the wiring harnesses from each

injector. Remove the four 10mm bolts

securing the fuel rails to the manifold. Pull

the fuel rails up off of the manifold to gain

access to the fuel injectors.

Remove the fuel injector retaining clips

from the injectors and rails. Remove the

injectors by pulling them straight out of

the rails.

Tech Tip: Lightly oiling the injector

o-rings eases installation.

Install the new injectors, followed by the

factory retaining clips.

Due to injector height, spacers must be

used to space the rail correctly. Mount the

spacers on the manifold, push the injector

and rail assembly into place, and tighten

the rails with the new hardware. Reinstall

each wiring harness to each injector.

FUEL SYSTEM

(FULL SYSTEMS ONLY)

Relay 46

Electrical Panel

Fuel Rails Installed

Rail Spacer

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

Keine Kommentare

Dodge 2006 LX Charger Installationsanleitung Seite 36