Dodge 2006 LX Charger Installationsanleitung PDF herunterladen (Seite 18)

Dodge Charger 2006-2008 System Installation Guide

Supercharger Crank Pulley

6.1L Crank Pinning

With a 10 mm socket, remove the

transmission access cover to access the

starter ring gear.

Lock up the transmission using

appropriate tool.

Remove the bolt from the center of the

balancer with a 21 mm socket.

Using a 3-jaw gear puller, remove the

factory balancer.

Install the ATI Performance Products

balancer per manufacturers instructions.

Place the drill jig onto the balancer hub,

tighten it into place using the supplied

M14-1.50 x 120mm hex head bolt and

washer.

Tape the supplied 1/4” HSS drill bit 1

5/8” from the tip. Using this taped drill,

drill a hole in the crankshaft and harmonic

balancer hub stopping at the tape edge of

the drill. The hole will be centered on the

OD of the crankshaft. Do not drill deeper

than .800” into the face of the crankshaft.

Remove the pinning tool and set aside.

Clean the chips from inside the drilled hole

and the surrounding area throroughly.

Install the supplied 1/4” OD x .75” long

stainless steel dowel pin in the hole.

EMOVING THE FACTORY BALANCER

DRILL JIG INSTALLED/DRILLING THE CRANK



7$3(

'5,//-,*

&5$1.3,11,1*),;785(

0',

0;%2/7

CRANKSHAFT AND HARMONIC BALANCER DRILL JIG

M14-1.50 x 120MM BOLT

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 52 53

Keine Kommentare

Dodge 2006 LX Charger Installationsanleitung Seite 18