Dodge 2000 Durango Bedienungsanleitung PDF herunterladen

THROTTLE BODY CLEANING

2000 DODGE DURANGO WITH 4.7L ENGINE

DISCLAIMER!

These instructions are based on my experience with removing and cleaning the throttle body and

from information obtained from the 2000 Durango Factory Service Manual. They were originally

my notes for use when I have to do it again. They are as complete and detailed as I can make

them, however they are provided for informational purposes only and you should follow or use

them at your own risk! Other year models may be different; other engines ARE different. If

something on yours seems different, it may well be! Use your head and be careful.

CREDITS

The basis for these instructions is the information provided on the Dakota-Durango web site at:

http://www.dakota-durango.com/performancetips.html

The instructions for cleaning the throttle body and IAC solenoid are near the bottom of this web

page, however it was written for the 5.2 and 5.9 liter engines. The 4.7 is slightly different.

TOOLS REQUIRED:

1. 8mm socket or nut driver

2. 10mm socket or nut driver

3. T-25 Torx screwdriver

4. Carburetor / Throttle Body cleaner

5. Compressed air (a compressor or just a can of compressed air from an office supply store)

6. Old toothbrush

7. Q-tips

8. Shop rags

9. Shallow pan for cleaning the throttle body in.

10. Safety glasses

11. A WELL VENTILATED place to clean the throttle body (read that as meaning outside if at all

possible!)

THROTTLE BODY REMOVAL STEPS

1. To prevent the engine from inadvertently starting remove the negative battery cable. Note

that this may cause you to lose settings in your radio and clock. Skip this step if desired, but

do so at your own risk!

2. If you have an aftermarket alarm system with a remote start capability and chose to skip Step

1, make certain your remote starter is in "Valet" mode or whatever is necessary to prevent the

engine from starting while the vehicle is being serviced.

3. Disconnect the hose between the air cleaner box and the air hat at the air hat end. There is a

hose clamp over the end of the hose. Loosen it using an 8mm socket and remove the hose

from the air hat (if necessary you can remove the hose entirely, but it should not be

necessary).

1 2 3 4

THROTTLE BODY CLEANING 1

Inhaltsverzeichnis

Seite 1 - THROTTLE BODY CLEANING

THROTTLE BODY CLEANING2000 DODGE DURANGO WITH 4.7L ENGINEDISCLAIMER!These instructions are based on my experience with removing and cleaning the throt

Seite 2

4. Remove the air hat from the throttle body.a) There are two 10mm bolts that need to be removed, one on the right side of the engine(your left as you

Seite 3

motor does not pull out of the throttle body easily, DO NOT force it. You can reach afinger into the hole in the throttle body at the end of the plun

Seite 4

Also make sure the proper side of the electrical connector is at the top (I don't think this reallymatters, but why take chances).4. If you remov