GROUND FOR AFTERMARKET CAMERAS12V CONSTANT OUTPUTCONNECT USB CABLE HERE FOR FUTURE UPDATESFRONT OR BABY CAM 12V POWER OUT12V ACC OUTPUTREVERSE CAM 12V
the UP position while the module is unplugged, and then plugging it back in and restarting the car. 5. The Lockpick will support the installation of
USB UPDATING (make sure module is also connected to Lockpick harness and vehicle) Your Lockpick V.3 interface includes the ability to be updated
Coastal Electronic Technologies, Inc. Chrysler/Dodge/Jeep MYGIG LOCKPICK™ V.3 Installation and Operation Instructions Thank you for your purchase
OK, let’s get started. On your MYGIG LOCKPICK V.3 control box are switch settings which allow you to program your Lockpick for the features you would
APPLICATION GUIDE ADDITIONAL VEHICLES MAY APPLY OR BE ADDED LATER IMPORTANT VEHICLE COMMUNICATION PROGRAMMING SETTINGS IDENTIFY YOUR VEHICLE FROM TH
COMMON SWITCH SETTINGS AND COMBINATIONS ADD SWITCH 5 DOWN TO BLOCK VIDEO IN MOTION (Dealer Mode) The MYGIG LOCKPICK will still
The MYGIG LOCKPICK V.3 is designed with a simple “T” harness connector, equipped with factory male and female connectors for direct connection
Installation of the REVERSE CAMERA POWER wire to enable factory camera operation in all gears is simply a matter of running a wire to the factor
MYGIG LOCKPICK V.3 OPERATION INSTRUCTIONS PRESS UCONNECT 2X: TURN ON REAR CAMERA TURN OFF ANY CAMERA CURRENTLY ON HOLD TO CHANGE DEFAULT SETTINGS AF
camera view and return to the standard radio view by pressing the Uconnect button 2x. The front camera will then stop displaying until the vehicle acc
Kommentare zu diesen Handbüchern